Versions Compared

Old Version 4

changes.mady.by.user Omry Koschitzky

Saved on

compared with

New Version 5

changes.mady.by.user Omry Koschitzky

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

In order for XpoLog to send SNMP Traps (mainly from System Status Console), you must allocate an SNMP server and configure it. 
View the XpoLog management information base (MIB) here

To configure SNMP settings:
  1. In the General Settings console, open the SNMP tabGo to XpoLog Manager left navigation panel Settings > System Settings
  2. Under the Notifications section click SET next to the SNMP part. The SNMP configuration screen opens.
  3. In SNMP Host, type the SNMP host address that XpoLog is to will use to send traps to.
  4. In SNMP Port, type the port that the given SNMP host is listening on.
  5. In Version, select Version 1 or Version 2 based on your SNMP server.
  6. check Proxy if needed (Default: un-checked).
  7. Click the Save button.
    The SNMP settings are saved.