Page Comparison

In order to use your Office 365 as the mail server that XpoLog uses to send emails, please use the following settings:

...

1. In the General Settings console, open the Mail tab
2. In SMTP Host, type your Office 365 mail exchanger (MX) record.
   A mail exchanger record (MX record) specifies the mail server responsible for accepting email messages on behalf of a domain name. It is a resource record in the Domain Name System (DNS). 
   The MX can usually be found in the Domains area of your office 365 portal. It is usually in the form of: ORG_NAME-com.mail.protection.outlook.com (under Office 365 Admin Center, Domains section. Click the domain you wish to use and the MX should be there).
3. In SMTP Port, type 25
   
4. System Email Address - typically this is the default/system ‘From’ email address that is to be used when sending emails from XpoLog. Enter an email address from this domain as the sender.
5. In Administrator Email Address, type the email address of XpoLog’s administrator, where system notifications such as disk space, violation messages, and more, are to be sent.
6. Check the Use SMTP Authentication check-box.
7. Provide SMTP Username and SMTP Password (your Office 365 full user (email address) and password)
8. Check the Use TLS/SSL check-box
9. Click the Save button.

...